HYD-2000
Innovative Technologies in Education (ITE)
HYD-2000
HYD-2100 Basic Hydraulics
- Module covers:
Applications, Physical Principles, Hydraulic Fluid, Types and Properties
|Component Recognition, Symbols and Standards |Design and Characteristic
Data |Calculation of Force, Speed, and Output, Uniform Pressure
Maintenance, Basic Circuits with Single and Double Acting Cylinders,
Cylinder Location, Differential Circuit with Input Flow Control,
2-way, 3-way and 4-way Valve Control, Check and Relieve Valves,
Sequential Cycle of Actuators.
HYD-2200 Advanced Hydraulics
- Module covers:
Pressure Compensated Flow Control Valves, Pilot Operated Check
Valves, Direct Operated Relief Valves, Hydraulic Accumulators, Emergency
use of Regenerative Circuits, Hydraulic Motors, Control of Reservoirs
and Fluid Conditioners, Flow Rate and Velocity, Hydraulic Pumps,
Pressure Dependant Sequence Control, Two Cylinder Synchronous Operation,
Rapid Feed with Multi Directional Valves, Controls with Independent
Circuits and Pressure Levels, Energy Conserving Speed Regulation,
Use of Residual Flow.
HYD-2300 Basic Electro-Hydraulics
- Module covers:
Fundamentals, Electrical Control, Advantages and Disadvantages,
Component Recognition, Symbology, Circuit Diagrams, Development
and Review, Manual and Automatic Control, Emergency Control, Ladder
Diagram Basics, Actuators, Direct and Indirect Control, Single Solenoid
Valve "Square" Cycle, Actuator Operation at Different
Speeds, Cylinder Reciprocation, Motor Control, Multiple Actuator
Operation, Electrical Pressure Control, Safety Shutdown Systems,
Time Delay Relay, Stroke and Pressure- Dependant Controls.
HYD-2400 Advanced Electro-Hydraulics
- Module covers:
Electronics Sensors, Function and Use, Optical, Capacitive and
Inductive Proximity Sensors, Symbology, Position Control, Sequence
Control, Time Delay Relay, Timing Control with Preset, Electrical
Counter, Logic Control, Troubleshooting.
HYD-2600 Computer Aided Instruction (CAI) Courseware Programs
- Module covers:
Comprehensive, interactive software specifically developed for
IBM PCs and compatible machines.
The software enables computer based design and simulation of large
and complex circuits and advanced control systems.
These can include electrical, electro-mechanical and electro-hydraulic
components as well as interconnected systems.
HYD-2500 PLC and Applications in Hydraulic Power Systems
- Module covers:
PLC, Introduction, Operation and Typical Structure, PLC versus
Conventional Control, Advantages and Disadvantages, CPU, Functions,
Inputs/Outputs, Ladder Diagrams, Definition and Design of Circuit
Development and Interfacing Criteria, Writing Programs, Counter,
Timer and Interrupt Programming, Troubleshooting Electro-hydraulic
Systems Using PLCs, Ladder Diagram and Function Chart Input Program,
Printout Program, Real Time Operation Monitoring Program.
|
